ESP32 Wi-Fi Radios Become Motion Sensors

Open-source ESPectre firmware detects movement by reading Wi-Fi channel data, a shipped capability still without published accuracy benchmarks.

Updated on Nov. 6, 2026 in Semiconductors

Bold vector editorial illustration of a green circuit board and a dark router linked by coral radio-wave arcs across an open field, with a faint moving silhouette in between.
Open-source ESPectre firmware turns the Wi-Fi radio in ESP32 microcontroller boards into a local motion sensor, no dedicated hardware needed. AI Illustration. Upload story photo >

ESPectre is open-source firmware that turns the Wi-Fi radio in ESP32 microcontroller boards into a motion sensor, with no dedicated sensor hardware. It supports the ESP32, ESP32-S2, S3, C3, C5 and C6 boards and runs detection locally without sending data to the cloud. The development is shipped firmware available to hobbyists and builders, not an announced product.

Why it matters

The approach detects motion by reading changes in Wi-Fi channel state information, so an ordinary wireless link doubles as a sensing channel. It points toward low-cost, cloud-free presence-style sensing built on hardware many smart-home builders already own.

The firmware's cost figure comes from a single colleague's Zigbee ESP32-C6 passive infrared build at $5. The source reports no measured detection accuracy against commercial sensors, and it is unclear how reliably the software performs across different rooms and router placements.

The players

ESPectre

Open-source ESP32 firmware project that repurposes Wi-Fi channel state information for local motion detection.

Home Assistant

Open-source home automation platform to which the ESPHome firmware option exposes ESPectre entities directly.

The details

ESPectre reads channel state information, which describes how a Wi-Fi signal's amplitude and phase change across subcarriers as it travels between two devices. By default it pings the Wi-Fi gateway to generate the steady packet traffic needed for these measurements. When a person moves, the radio path between router and board shifts, and that shift shows up in the channel data the firmware analyzes.

The Tech Race

Dedicated motion sensors in smart homes have typically relied on separate passive infrared or radar hardware, while ESPectre applies a software-only approach to the Wi-Fi radios already present on ESP32 boards. The source does not place the project against a named competing research program or product roadmap.

Builders with supported ESP32, S2, S3, C3, C5 or C6 boards can flash ESPectre and use the Wi-Fi radio for motion detection without buying separate sensors. The source does not give a timeline for wider adoption or a reliability guarantee for everyday home use.

The takeaway

Watch whether independent builders publish accuracy comparisons between ESPectre's Lightweight and High Accuracy modes and commercial PIR sensors. Those results would show whether software-defined Wi-Fi sensing can match dedicated hardware in ordinary rooms.

Further reading

For the chip architecture behind this approach, see our coverage of Semiconductors.

Source note: This article includes information reported by XDA-Developers.