We Are the Frontier

Electronics-Free Soft Robot Runs 4.72 m/s

The 3D-printed, air-powered machine is a lab result in Science Robotics, not a product, with untethered operation still to be built.

Updated on Nov. 19, 2026 in Tech

Isometric editorial illustration of a compact six-legged soft robot with stacked air chambers resting on a pale lab bench beside a clear air tube.
UC San Diego engineers built an electronics-free, 3D-printed six-legged soft robot that runs up to 4.72 meters per second, reported in Science Robotics on November 18, 2026. AI Illustration. Upload story photo >

UC San Diego engineers built a six-legged, 3D-printed soft robot that runs up to 4.72 meters per second without any electronics. The research, reported in the November 18, 2026 issue of Science Robotics, is at the research stage and is not a commercial product.

Why it matters

The result shows that a soft robot can be made in one piece from a single material and still move fast, with its control built into its air-powered mechanics rather than onboard circuitry. That points toward robots that could operate where electronics are fragile or impractical.

The robot's measured top speed is 4.72 meters per second, against 4 centimeters per second for the 2022 version of the design. The reported figures do not include battery-free endurance or payload data, which were not part of the disclosed results.

The players

UC San Diego Jacobs School of Engineering

The engineering school at the University of California, San Diego, which conducted the research on soft robotics and 3D-printed actuators.

Science Robotics

A peer-reviewed journal published by the American Association for the Advancement of Science that reports on robotics research.

National Science Foundation

The U.S. federal agency that funded the research, and a major sponsor of basic engineering and robotics science.

The details

The robot's legs are driven by pressurized air rather than motors or circuit boards. The design adapts a compound steam engine, so air circulates twice: first through smaller high-pressure chambers that operate the valves, then through larger low-pressure chambers that move the legs. Higher pressure alone made the robot inefficient, because high-pressure air was exhausted while still holding usable energy, and the two-stage arrangement recovers that energy.

Timeline

  1. 2022: The team developed the first 3D-printed air-powered soft walking robot.

  2. 2025: An earlier robot was detailed in an Advanced Intelligent Systems article.

  3. November 18, 2026: The new research was reported in Science Robotics.

The Tech Race

The result follows the UC San Diego team's own 2022 air-powered soft walking robot, which set the baseline this design improves on by more than 100 times in speed. It sits in the broader push to build soft robots whose control is embedded in their materials and pneumatics rather than in electronics.

The robot is a laboratory research result and is not available for purchase or use. Its practical reach depends on a future version that runs on a portable air supply, which the researchers plan to develop but have not dated.

The takeaway

Watch for whether the team demonstrates the robot running untethered on a portable air source, since that is the step needed before field use. A follow-up design with steering and object manipulation would show whether the control approach scales beyond straight-line running.

Further reading

For more on the field this work belongs to, explore the Robotics coverage on our site.