3D-Printed Tungsten Tiles Survive Fusion Plasma Test
Full-size printed tungsten tiles were exposed in a working fusion reactor, a research-stage step toward printed fusion components.
Updated on Nov. 5, 2026 in Science

NC State researchers installed 3D-printed tungsten tiles in the lower divertor of General Atomics' DIII-D fusion tokamak in July 2026, and the tiles absorbed three days of direct plasma exposure across 74 high-confinement discharges. The tiles are now being removed, imaged and surface-scanned, with NC State leading the analysis. The work is at the research stage: the results are not yet reported.
Why it matters
Fusion reactors need plasma-facing components that survive extreme heat, and tungsten is a leading candidate but is hard to shape into large parts. Printing full-scale tiles, rather than the small buttons tested in 2025, moves additive manufacturing closer to the size that a reactor component would require.
The tiles were tested over three days of direct plasma exposure across 74 high-confinement H-mode discharges at medium-to-high power, compared with the 2025 button tests that saw heat fluxes near 20 MW/m2 with brief peaks above 35 MW/m2. Whether the full-size tiles held up under those conditions has not yet been reported, since analysis is still underway.
The players
NC State University
A North Carolina research university whose additive-manufacturing group designed the tungsten tiles and will lead their post-test analysis.
DIII-D
General Atomics' tokamak fusion facility in San Diego, used here to expose tungsten components to reactor-like plasma.
Oak Ridge National Laboratory
A U.S. Department of Energy lab that developed the electron-beam additive manufacturing methods used to print the tiles.
The details
Tungsten is melted layer by layer using electron-beam powder bed fusion, a process in which an electron beam fuses metal powder inside a vacuum chamber. The tiles were printed on JEOL's JAM-5200EBM large-format system and mounted on copper-alloy pedestals before being installed in DIII-D's lower divertor, the component that absorbs the hottest exhaust from the plasma. After printing, NC State machined the tiles to finish their shape and produce mirror-like plasma-facing surfaces.
Timeline
2025: small printed tungsten buttons were tested at DIII-D's Divertor Materials Evaluation System.
July 2026: the printed tiles were installed in DIII-D's lower divertor.
2026 Tile Testing Campaign: the tiles received three days of plasma exposure and 74 discharges.
The Tech Race
Plasma-facing materials are a bottleneck for fusion, and tungsten is the leading candidate. This test pushes printed tungsten from roughly 50-millimeter parts to 140 × 130-millimeter tiles in an operating tokamak.
This is a research-stage test, so the tiles are not available for use in any reactor today. Timelines for applying printed tungsten components in commercial fusion plants have not been announced.
The takeaway
Watch for NC State's post-exposure imaging and surface-scan results on the tiles, which will show whether printed tungsten held up at full size. The results will determine whether additive manufacturing can be scaled for fusion plasma-facing components.
Further reading
For more on the research behind this test, see the Nuclear section.





